DD Slimline designer bracket

The DD Slimline Designer Bracket is a sleek and elegant solution to mount your AI Hydra lights directly on the back of your aquarium. Designed in-house and manufactured in the UK, this large aluminum bracket allows you to manipulate your Ai lighting in style.

Available in black or silver powder coating.

3 sizes available:

HTM50 – for 50 cm wide tanks.
HTM60 – for 60 cm wide tanks.
HTM75 – for 75 cm wide tanks.

Characteristics:

Easy to install
Elegant design
Height adjustable
Dual mounting points for secure mounting
Lightweight aluminum
Available in three sizes for aquariums of 50, 60 and 75 cm wide
Suitable for Hydra (thin heatsink), Vega, Hydra 52/26 and Hydra 52 / 26HD

Assembly instructions

Remove the grill from your Ai lamp by gently pulling it up from the center.
Slide the light on the bracket with the status light towards the holder (be careful not to damage the HD line crystal indicator when installing)
Put the grill in place and place it on the light
Install the mounting clamps and tighten the black hex screws with the included Allen wrench to secure the clamps to the bracket.
Screw the long, plastic black clamp bolt into the clamp and screw the included black plastic nut onto the screw thread with the flame edge facing the aquarium glass.
Place the holder on the aquarium and clamp the brackets, to adjust the height of the light, loosen the black nex bolts on the back of the mounting clamps and lower or lower the bracket.
The mounting clamps are very secure, so it is best to adjust with the light off the clamp and the clamp away from the aquarium.
Stick the supplied cable guides to the holder, one to route the cable as it exits the light and the other to the back of the holder to route the cable as it runs along the back of the holder.
The holder is designed to clamp directly to glass or a rigid and secure curb or pelmet. Do not attempt to mount the clamp on a pelmet that cannot support the weight of the bracket and light as the bracket may tip forward or in worst case the lamp will fall into the aquarium if the pelmet is not designed to hold a Carry such cargo.

 Beugelafmetingen

 Bracket installatie